Xantrex Technology Link 1000 - Manual (Page 19)

Installing the Link 1000
11
Installing the Link 1000
Overview of Installation Steps
Complete the installation in this order. Refer to Figure 2 .
1. Mount the control panel ( page 13 ).
2. Mount the shunt, and cable it to the negative battery
terminal. Cable the load side of the shunt to the negative
bus for DC loads (
page 14 ).
3. Connect wires to the Link 1000 terminal block ( page 15 ).
4. Connect wires from the terminal block to the shunt and to
the battery’s positive terminal ( page 16 ).
5. Install the fuses ( page 17 ).
6. Connect the phone cable to the control panel and the
inverter/charger ( page 17 ).