ZyXEL Communications GS-4012F/4024 - Manual (Page 284)

GS-4012F/4024 User’s Guide
Chapter 42 Introducing Commands 283
42.11.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
<SPTPID> Sets the SP TPID (Service
Provider Tag Protocol Identifier).
13
vlan-type <802.1q|port-
based>
Specifies the VLAN type. 13
Table 106 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 107 interface port-channel Commands
COMMAND DESCRIPTION PRIVILEGE
interface
port-
channel
<port-
list>
Enables a port or a list of ports for
configuration.
13
bandwidth-limit Enables ingress (pir), cir and
egress limits on the port(s).
13
cir Enables the guaranteed bandwidth
limits for incoming traffic on the
port(s).
13
cir <Kbps> Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir <Kbps> Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
egress Enables bandwidth limits allowed
for outgoing traffic on the port(s).
13
egress <Kbps> Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
bpdu-control
<peer|tunnel|di
scard|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
13
broadcast-limit Enables broadcast storm control
limit on the port(s).
13
<pkt/s> Specifies the maximum number of
broadcast packets to allow through
the port.
13
diffserv Enables DiffServ on the port(s). 13
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
13