Zebra Technologies Zebra Z4000 - Manual (Page 10)

For shipping information, refer to Appendix C.
Communications
Refer to Figure 1. The Z Series™ printer comes standard with both an
Electronics Industries Association (EIA) RS-232 serial data interface(a)
and a bi-directional parallel interface(b) compliant with the IEEE1284
standard. The serial interface is also configured for both RS-422/
RS-485 single drop and RS-485 multi-drop communication modes.
NOTE: You must supply the interface cable for your application. See
Appendix B of this manual for specific cable requirements.
Printer Power
The Power Supply in the Z Series™ printer automatically detects the
applied line voltage and works in the 90 to 265 VAC range.
Refer to Figure 1. The AC Power Cord must have a three-prong female
connector on one end which plugs into the mating connector(c) at the
rear of the printer. If a power cable was not included with your printer,
refer to Appendix C at the back of this guide.
WARNING!! For personnel and equipment safety, always use
a three-prong plug with an earth ground connection to the
AC Power Source.
Refer to Figure 1. Insure that the AC Power ON/OFF Switch(d) is in
the OFF (O) position before connecting the AC Power cord to a nearby
electrical outlet.
2 Z Series™ User’s Guide
c
d
b
a
Figure 1. Printer Rear View
10
H:...uspiran2.vp
Mon Jun 22 10:28:46 1998
Color profile: Disabled
Composite Default screen