Zebra Technologies Zebra Z4000 - Manual (Page 75)

Z Series™ User’s Guide 67
CALIBRATION
PARAMETER SELECTIONS
MEDIA POWER UP
(password
required)
This parameter establishes the action of the media
when the printer is turned ON.
Default: Calibration
Choices: Calibration - recalibrates media and ribbon
sensors by feeding labels
Feed - feeds the label to the first web
Length - determines the length of the label
by feeding labels
No Motion - media does not move
HEAD CLOSE
(password
required)
This parameter establishes the action of the media
after the printhead has been opened and then
closed.
Default: Calibration
Choices: Calibration - recalibrates media and ribbon
sensors by feeding labels
Feed - feeds the label to the first web
Length - determines the length of the label
by feeding labels
No Motion - media does not move
MANUAL CALIBRATE If the auto-calibration feature has been disabled by a
ZPL command from the host or the HEAD CLOSE
parameter is not “Calibrate”, you may use this
feature to calibrate the media and ribbon sensors.
Press “+” to enable the Calibration process.
NOTE: If the printer is configured for continuous
media, no media movement will occur during
the Calibration process.
SENSOR PROFILE The Media and Ribbon Sensor Profile provides a
graphical representation of the Media and Ribbon
Sensor settings as an aid to the Service Technician if
problems with inter-label gap sensing occur.
Press “+” to enable the Sensor Profile printout.
WEB S.
THESE SETTINGS SHOULD ONLY BE CHANGED
BY AN AUTHORIZED SERVICE TECHNICIAN.
(A password is required)
Refer to the Z Series Maintenance Manual for
additional information about these settings.
MEDIA S.
RIBBON S.
MEDIA LED
RIBBON LED
Continued on the following page.
75
H:...uspiran2.vp
Thu Jun 18 16:03:36 1998
Color profile: Disabled
Composite Default screen