Zebra Technologies Zebra Z4000 - Manual (Page 55)

Initializing the Flash Memory and
PCMCIA Card
As of Firmware release V22.8.4, a new procedure is used to initialize
the optional on-board Flash Menory device and the optional PCMCIA
Card.
Prior to uploading new contents into the Flash Memory and/or the
PCMCIA Card, it is first necessary to initialize these devices. This pro-
cedure is performed by pressing and holding all three left hand control
keys inside the printer's front panel door while turning the printer
power ON. The keys may be released anytime after the first front panel
LED turns OFF. The Front Panel DATA LED will remain on until the
initialization process is finished.
NOTE: Initialization will erase the current contents of both devices.
Be sure to enable the Write Protect feature of the PCMCIA Card if you do
not want to initialize this device.
Automatically Executed Format
Once the Power On Self Test is completed and any self test labels are
printed, a check is made of the optional PCMCIA Memory Card and
then the optional Flash Memory for the presence of a stored format
named AUTOEXEC.ZPL. If an AUTOEXEC.ZPL format is encoun-
tered, it is automatically recalled and the preformatted labels are
printed.
If no AUTOEXEC.ZPL format is found, the printer enters the normal
operating mode and waits for operator input from the front panel or la-
bel format data to be received from the host computer.
Z Series™ User’s Guide 47
55
H:...uspiran2.vp
Thu Jun 18 16:02:08 1998
Color profile: Disabled
Composite Default screen