Edimax Technology IC-7000PTn V2 - Manual (Page 17)

2.2 Pan and Tilt
This IP camera supports pan and tilt function, as you explored in last section. You can also make the camera
move automatically in pan and tilt menu by defining a set of pre-defined path.
You can access this menu by clicking ‘PTZ’ on the top of web management interface.
2.2.1 Preset Points
You can define the camera position and save the position so you can recall the position later again. This
camera provides 9 memory slots; follow the following instructions to move the camera and set a new preset
point:
UP
RIGHT LEFT
UPPER
LEFT
UPPER
RIGHT
LOWER
RIGHT
LOWER
LEFT
DOWN
1. Select a memory slot from ‘Available Positions’ dropdown menu first.
2. To move the camera, click the position of labeled text (not shown on image) on the image to move the
camera to the direction. You may need to set the Pan / Tilt speed to a slower setting, so you can move the
camera in a more accurate manner.
3. When you move the camera to the position you want, type a name in ‘Position name’ field, and click ‘Set to
Point n’ (where ‘n’ is the number of memory slot) button to save the position to selected memory slot.
After you set the position, you can recall the position from ‘Camera’ menu (click the position number button),
and the camera will move to preset position instantly.
If you want to remove a preset position, select the memory slot from ‘Available Positions’ dropdown menu,
and then click ‘Remove Point n’, (where ‘n’ is the number of memory slot you wish to clear position setting).
17