Edimax Technology IC-7000PTn V2 - Manual (Page 31)

2.4.1 Motion Detection
You can use this menu to setup basic motion detection settings:
The descriptions of every setting in this menu will be given below:
Item Description
Enable Motion
Detection
Select ‘Enable’ to enable motion detection, and select ‘Disable’ to disable this
function.
Motion Detection
Interval
Select the time interval between two motions from dropdown menu. When a
motion is detected, camera will not detect any motion again within the time interval
you specified here. Available options are from 0 second (always detect new
motion) to 60 seconds.
Recording Time
Select the duration you wish this camera to record image when a motion is
detected from dropdown menu. Available options are 1, 2, 3, 4, and 5 (seconds).
Sending File Type
Select the file type that will be saved when a motion is detected. Select ‘JPEG’ and
a still picture in JPEG format will be saved; and select ‘AVI’ to save a motion video
clip.
Send snapshot
file to FTP
Select ‘Enable’ to send the saved file to appointed FTP server when a motion is
detected, select’ Disable’ to disable this function. You have to configure FTP server
parameters in ‘FTP Configuration’ menu first, so this function will take effect (see
below).
Send snapshot
file to E-Mail
Select ‘Enable’ to send the saved file to appointed E-mail address when a motion
is detected, select’ Disable’ to disable this function. You have to configure mail
server parameters in ‘FTP Configuration’ menu first, so this function will take effect
(see below).
Send snapshot
file to SD Card
Select ‘Enable’ to send the saved file to SD card when a motion is detected, select’
Disable’ to disable this function. You have to insert a working SD card into the SD
slot of this camera first, so this function will take effect.
Click ‘Apply’ to save settings and make the new settings take effect.
31