HONDA 2011 Odyssey - Manual (Page 634)

CONTINUED
Remove the socket for that bulb
by turning it one-quarter turn
counterclockwise.
Determine which of the two bulbs
is burned out: stop/taillight or turn
signal light.
Rotate the assembly toward the
side panel until it slightly overlaps
the bumper and the bottom of the
taillight housing is exposed.
With the hand closest to the cargo
area, use your fingers to grip the
bottom edge of the assembly.
Apply a rearward and upward
pulling motion to release the lower
fastener from the grommet.
Continue to support the assembly
while placing the fingers of the
outer hand on the top of the outer
corner of the assembly.
Pull with the upper finger and
hand to release the upper fastener
from the top grommet.
2.
3.
4.
5.
6.
7.
8.
Lights
Ma
int
e
na
nce
631
BULB
SNAP FASTENERS
SOCKET
10/07/17 10:58:44 31TK8600_636
2011 Odyssey