HONDA 2011 Odyssey - Manual (Page 647)

A tire this worn gives very little
traction on wet roads. You should
replace the tire if you can see three
or more tread wear indicators.
Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a 1/2
inch (12.7 mm) wide band across the
tread. This shows there is less than
1/16 inch (1.6 mm) of tread left on
the tire.
For convenience, the recommended
tire sizes and cold tire pressures are
on a label on the driver’s doorjamb.
For additional information about
your tires, see page
.
We strongly recommend that you do
not drive faster than the posted
speed limits and conditions allow. If
you ever drive in a sanctioned
competitive event at sustained high
speeds (over 99 mph or 160 km/h),
be sure to adjust the cold tire
pressures as shown below. If you do
not, excessive heat can build up and
cause sudden tire failure.
Excessive tread wear.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see fabric or cord.
Bumps or bulges in the tread or
side of the tire. Replace the tire if
you find either of these conditions.
Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
You should look for:
690
Cold Tire Pressure Tire Size
Tire Size Cold Tire Pressure
Front:
Rear:
Front:
Rear:
LX, EX, EX-L models
Touring models
Tires
High Speed Driving Tire Inspection
644
INDICATOR LOCATION MARKS
TREAD WEAR INDICATOR
P235/65R17 103T
33 psi (230 kPa ,
2.3 kgf/cm )
35 psi (240 kPa ,
2.4 kgf/cm )
P235/60R18 102T
36 psi (250 kPa ,
2.5 kgf/cm )
35 psi (240 kPa ,
2.4 kgf/cm )
10/07/17 11:00:41 31TK8600_649
2011 Odyssey