HONDA 2011 Odyssey - Manual (Page 96)

CONTINUED
On Touring Models
You can customize some vehicle
control settings. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park.
To enter the customizing mode,
press either INFO button (
/ )
repeatedly until ‘‘CUSTOMIZE
SETTINGS’’ is displayed, then press
the SEL/RESET button.
If you try to enter the customizing
mode while the vehicle is moving,
you will see a ‘‘MUST STOP AND
SHIFT TO PARK TO CHANGE
SETTINGS’’ message and you
cannot change the settings.
You can customize some vehicle
control settings for ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately. If ‘‘DRIVER
1’’ or ‘‘DRIVER 2’’ is not displayed,
customizing is not possible.
To have the driver’s ID detected,
make sure your remote transmitter
is linked to the system and the
driver’s door is unlocked with a
corresponding remote transmitter.
If you want the settings as they were
when the vehicle left the factory,
select DEFAULT ALL, as described
on page
.
If you want to change any vehicle
control settings, select CHANGE
SETTINGS, then press the SEL/
RESET button.
Refer to the table on the next page
about the settings you can customize.
96
Multi-Information Display
Customized Settings
Inst
ru
ment
s
a
nd
Cont
ro
ls
93
DRIVER’S ID
10/07/17 09:47:14 31TK8600_098
2011 Odyssey