AASTRA 620d for Aastra 400 User Guide EN - Manual (Page 57)

Supplementary features
eud-1291/1.0 – R1.0 – 01.2011
57
Activating ring alone
You want to specify which of your phones shall ring acoustically when you receive a
call.
When your system administrator has set up a phone number with several phones, you
can define on which phones a call shall acoustically be signalled using ring alone.
When you have activated ring alone on a phone, the acoustic ringing tone is deacti-
vated for all other phones ( ). An incoming call is signalled in the display of all
phones. You can answer the call on each of your phones.
This function must be stored under a function key (see chapter "Configuring keys" ,
page 85 ).
Activating / deactivating room monitoring (Baby surveillance)
You want to use your cordless phone to observe acoustic monitoring tasks, for exam-
ple to monitor a toddler.
You can activate a room monitoring mode on your cordless phone. You can select
between active and passive room monitoring.
Activate the room monitoring on your cordless phone. The microphone for room
monitoring is activated after a delay of 10, 20 or 30 seconds. Use this time lag to posi-
tion the cordless phone in the room where you want e.g. to monitor your child and
leave the room.
Note:
When you have activated ring alone but deactivated the personal call routing for a
phone in parallel, an incoming call is not acoustically but only visually signalled.
In the idle state:
Press the function key for <Ring alone> .
➔
Ring alone is activated/deactivated.