EVS IPDirector Version 6.2 - June 2013 VTR CONTROL PANEL User Manual - Manual (Page 11)

Area Description
The table below describes the various parts of the VTR Control Panel:
Area Description
1. Transport
Functions
pane This pane provides the basic functions to move through a tape
media.
See section "Transport Functions Pane" on page 5.
2. Clip
Creation
pane This pane provides the basic functions to create a clip from a tape
media.
See section "Clip Creation Pane" on page 7.
3. Clip
Information
pane This pane allows the users to enter information about the clip to
digitize, to select destination targets, to select the digitize type and
to start the single clip digitization process.
See section "Clip Information Pane" on page 9.
4. Batch List
pane This pane provides the functions to digitize a series of clips at once.
See section "Batch List Pane" on page 13.
5. Status bar The status bar shows the current status of the VTR Control Panel.
IPDirector - Version 6.2 - User Manual - VTRControl Panel
2. User Interface 3