EVS IPDirector Version 6.2 - June 2013 VTR CONTROL PANEL User Manual - Manual (Page 17)

1. IN field: timecode of the IN point
2. Duration field: time interval between the IN and OUT points, i.e. clip duration
3. OUT field: timecode of the OUT point
2.4.4. Recorder Contextual Menu
A contextual menu appears when you right-click the Recorder Channel field.
The following table describes the commands available from the contextual menu.
Menu Item Description
None Removes the association between the VTR Control Panel and
the recorder.
[List of recorder
channels from
available EVS
video servers] Provides the list of recorder channels available on the XNet
network, and visible to the current user, which can be assigned
to the VTR Control Panel and used to digitize a tape to an EVS
video server.
Depending on the EVS server configurations, up to 6 recorder
channels can be available per server.
2.5. Clip Information Pane
2.5.1. Introduction
The Clip Information pane allows the users to enter information about the clip to digitize
and to select destination targets, to select the digitize type and to start the single clip
digitization process.
2.5.2. Overview of the Clip Information Pane
Illustration
The Clip Information pane contains the areas highlighted on the screenshot below:
IPDirector - Version 6.2 - User Manual - VTRControl Panel
2. User Interface 9