EVS IPDirector Version 6.2 - June 2013 VTR CONTROL PANEL User Manual - Manual (Page 31)

5.4. Selecting the Clip Digitization Type
The different options available to digitize a tape, or a portion of it, are shown in the Digitize
Types area of the Clip Information pane. The table below describes the use of each
option.
Option Used for
Auto Edit the digitization of a selected portion of tape.
Complete Tape the digitization of an entire tape into a single clip.
Complete Tape +
Duration the digitization of a media for a selected duration from the
beginning of the tape.
Derush the digitization of an entire tape into as many clips as there are
timecode disruptions.
5.5. Creating a Clip by Marking
Boundaries on Tape
5.5.1. Introduction
When the Auto Edit option is selected, to digitize a portion of tape, users can mark the
boundaries of a clip from the tape media thanks to the clip creation functions of the Clip
Creation pane.
5.5.2. Clip Creation Buttons and Shortcuts
The following table gives the meaning of each clip creation operation. A button and/or a
keyboard shortcut can be used to perform each action. The ShuttlePRO device has
buttons dedicated to most of these functions as well.
Operation
User
Interface
Button
Keyboard
Shortcut
Description
Mark IN Sets an IN point at the timecode shown in
the Current Timecode field.
Mark
OUT Sets an OUT point at the timecode shown
in the Current Timecode field.
Clear IN Clears the IN point which has just been
set.
IPDirector - Version 6.2 - User Manual - VTRControl Panel
5. Digitizing a Clip 23