How to mark a clip on a tape – EVS IPDirector Version 6.2 - June 2013 VTR CONTROL PANEL User Manual User Manual
Page 32
Operation
User
Interface
Button
Keyboard
Shortcut
Description
+
Clear
OUT
+
Clears the OUT point which has just been
set.
Goto IN
Moves the current position to the Mark IN
point of a clip being digitized.
Goto
OUT
Moves the current position to the Mark
OUT point of a clip being digitized.
5.5.3.
How to Mark a Clip on a Tape
To mark a portion of a tape media, proceed as follows:
1. Mark an IN point in one of the following ways:
◦
Use the clip creation function (button or shortcut) to set an IN point at the required
timecode.
◦
Enter the timecode of the requested IN point in the IN field and press ENTER.
The IN point is set:
2. Mark an OUT point in one of the following ways:
◦
Use the clip creation function to set an OUT point at the required timecode
◦
Enter the timecode of the requested OUT point in the OUT field and press
ENTER.
The OUT point is set:
The clip duration is displayed in the Duration field.
Note
No guardbands are kept.
24
5. Digitizing a Clip
EVS Broadcast Equipment S.A. - June 2013
Issue 6.2.A