Digitizing a batch of clips, Purpose, Process overview – EVS IPDirector Version 6.2 - June 2013 VTR CONTROL PANEL User Manual User Manual
Page 34: Managing batch lists, How to create a batch list
6.
Digitizing a Batch of Clips
6.1.
Purpose
In Batch Digitize Mode, several clips can be queued in a Batch list, so that they will all be
digitized in one process run.
6.2.
Process Overview
The process of digitizing a batch of clips can be summarized by the following steps.
Step
See section...
1.
Create a batch list.
OR
Open an existing batch list.
"How to Create a Batch List" on
page 26 and "Batch List
Management Buttons" on page
14.
2.
Create a clip
•
with Auto Edit option
•
with Complete Tape option
•
with Complete Tape and Duration
options
"How to Mark a Clip on a Tape" on
page 24 and "Process Overview"
on page 19.
3.
Add the clip to the batch list
•
Click the Add to Batch button.
Note
The Add to Batch button cannot be used with the Derush digitization
type.
4.
Repeat steps 2 and 3 to add more clips to the batch list.
5.
Start the digitization process
•
Click the Batch Digitize button.
6.3.
Managing Batch Lists
6.3.1.
How to Create a Batch List
To create a Batch List, proceed as follows:
1. Click the New button.
The New Batch List window opens.
26
6. Digitizing a Batch of Clips
EVS Broadcast Equipment S.A. - June 2013
Issue 6.2.A