EVS XT3 Version 11.00 Configuration Manual - Manual (Page 13)

The following screenshot presents the Multicam Setup window in the web-based
interface:
Description of the Areas
The table below describes the various parts of Multicam Setup window:
# Name of area Description
1. Title bar The title bar displays the following information:
• Multicam version
• server facility name (if any)
• chassis type
• server serial number
2. Configuration Lines This area shows all configurations the EVS server can
run:
• 16 configurations lines are available on an EVS
server. A default configuration is defined behind all
configuration lines, even if no name is assigned to
the configuration line.
• Each configuration line contains all configuration
parameters, which allow a very flexible
configuration of the EVS server.
For more information, see section "Configuration Lines"
on page 11.
3. Tools This area provides the main commands for server
administration and maintenance.
For more information, click the Tools command below
to go to the dedicated sections in the Multicam Setup
chapter:
7 2. Multicam Setup
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C