Video and reference, Video and reference settings, Introduction – EVS XT3 Version 11.00 Configuration Manual User Manual
Page 58: Field rate
Setting Name
Basic
Advanced
Technical
Setup
group
P1
IP Address
X
X
Subnet Mask
X
X
Default Gateway
X
X
3.2.2.
Video and Reference
Video and Reference Settings
Introduction
The Video and Reference settings are available on the Server tab in the server-based
application (1st page) and web-based interface. These settings are not available in the
Technical Setup menu of the Remote Panel.
Warning
Most Video and Reference settings (all except Sync PC time and Genlock)
require an application reboot (ALT+Q from the operational windows) for changes
to be taken into account.
The Video and Reference settings are highlighted in the screenshot of the server-based
application shown below:
Field Rate
Description
Field frequency used (Hz).
Both field rate and resolution give the video standard.
Values
50.00 Hz (PAL) - default
59.94 Hz (NTSC)
59.94 Hz (J)
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration
52