Hotchkis 80112 1970-1974 Plymouth Cuda TVS System - Manual (Page 33)

1R. Raise the Vehicle, Remove Rear Bar
Installation must be done at ride height. Drive vehicle on to ramps, or use a 4-post alignment
style rack. If your vehicle has a factory sway bar, jack up the vehicle and support with jack
stands, remove one wheel, remove end links and bushing brackets, and slide bar out side of
vehicle. Install wheel, and lower vehicle back down to ride height.
2R. Install Axle Brackets
Hang the bushing bracket u-bolts over the axle tubes.
3R. Install Bushings & Brackets
Apply grease to the new bushings with the supplied grease, install onto sway bar, and press
bushing brackets over bushings.
4R. Attach bar to Axle
Installation of Hotchkis Rear Sway Bar