Hotchkis 80112 1970-1974 Plymouth Cuda TVS System User Manual
Page 5
1110 66-70 B-Body, 70-14 E-Body
Hotchkis Performance LLC.
5
7. Install A-Arm Front Mount
Use hardware kit 17101 and install the split lock washer & AN washer onto each
½” socket-head bolt. Included in you’re A-Arm kit will be an assortment of
aluminum spacers with varying thicknesses. Grab one 0.185” spacer for each
Relocator. Insert the socket-head bolt slightly into the bottom hole of the A-Arm
Relocator just enough so you can rest the spacer on the tip of it on the inside of
the Relocator as shown below. Next, slide the A-Arm into place, slide bolt all the
way through, then fully tighten. See bottom picture for full detail.
Stack Up: 3/8” bolt---Split Lock washer---AN Washer---Relocator---
0.185” Spacer---Misalignment Spacer---Heim Joint