Hotchkis 80112 1970-1974 Plymouth Cuda TVS System - Manual (Page 7)

1110 66-70 B-Body, 70-14 E-Body
Hotchkis Performance LLC.
7
Once the proper spacer arrangement is achieved, insert the camber bolt
through the stock mount hole and the other end will end up in the engine bay.
Install the camber washer and nut. Adjust the bolt so that the bolt is in the
center of its adjustment. Fully tighten nut for now. This will be adjusted once you
get an alignment.
9. Connect A-Arm to Spindle
Lift the A-Arm and lineup the ball joint stud to the hole in the spindle and slide
the stud in.