Hotchkis 22407R Subaru WRX Autocross Rear Sway Bar - Manual (Page 4)

7) Use the grease provided to apply a thick coat of grease to the inside of the new bushings and
slide the bushings over the bar. Some early models of the bar may have centering washers.
These have since been removed, as they were found unnecessary with the Hotchkis bar.
If you have washers on your bar the bushing goes to the outside of the washer.
8) Lift the Hotchkis sway bar into position the same way the stock sway bar came out. Use the
stock mounting brackets and hardware to secure the new sway bar in place.
Use a 12mm wrench to tighten the hardware. It may be easier to rotate the bar and connect it to the
end links in the following steps with the bushings still slightly loose. Torque the bolts to 30ft/lbs.