Hotchkis 22407R Subaru WRX Autocross Rear Sway Bar - Manual (Page 8)

6) Use the grease pack included to apply a thick coat of grease to the insides of the new sway bar
bushings. Then place the bushings over the sway bar with the split in the bushing towards the
front of the vehicle. Place the bushing retainer brackets over the bushings. Insert the four
remaining flange head bolts into the brackets from the backside.
7) Use a 12mm wrench or socket to hold the bolt head and a 13mm wrench or socket to tighten
the nylock nut to mount the sway bar to the bracket. Torque the hardware to 30ft/lbs.
8) Reconnect the end links to the sway bar using a 14mm wrench or socket. Torque the hardware
to 30ft/lbs. You may have to lower the car to the ground to rotate the bar to match the end links.