Hotchkis 22407R Subaru WRX Autocross Rear Sway Bar - Manual (Page 5)

9) Rotate the Hotchkis sway bar into position until you can re-connect the end links. For stock end
links you should use the 14mm wrench and 5mm Allen wrench you used to remove the nut.
Torque the end link nut to 30ft/lbs.
10) Re-install the sub frame.
11) Re-install the skid plate and check all hardware for tightness . Install the splashguard to finish.
MOVE ON TO THE REAR BAR INSTALLATION