Hotchkis 80110 1966-1969 Mopar B-Body TVS System - Manual (Page 31)

Use a paint marker to mark where the holes are as well as the outer edges that mate with the
k-frame. (Picture shows bracket disconnected from the sway bar for clarity purposes.
7. Once the k-frame is marked, use an angle grinder with a sand paper attachment to remove
all of the paint and grime on the areas previously marked. What we are doing is cleaning
the area that is going to be welded. You will also need to sand the bushing retainer
bracket in the mating areas too.
8. Reposition the bar back onto the k-frame so the retainer bracket is sitting flush with the k-
frame. A jack does a good job of holding the bar in place for you. You will now weld the
bracket to the k-frame. The best way to start is to tack weld a couple of spots around the
bracket. Once the brackets are secure, unbolt the D-shaped bushing bracket and end links
to get the bar out of the way. Finish welding a bead as shown in the picture below. Also
weld up the holes creating a rosette weld.