Hotchkis 80110 1966-1969 Mopar B-Body TVS System - Manual (Page 35)

7) Place the u-bolts over the rear axle. Slide the axle brackets over the ends of the u-bolts
with the curved side up against the axle. Rotate the bar into position and slide the bushing
retainer brackets over the ends of the u-bolts. Start the nylock nuts onto the ends of the u-bolts
to loosely hold the bar to the axle.
8) Use the tube of anti-seize included with the kit to apply a small amount to each set of
threads on the u-bolt. DO NOT tighten the nylock nuts without using anti-seize! You could ruin
the nuts or snap the u-bolt without it.
9) Make certain that the rear axle is at normal ride height to establish the proper
orientation of the sway bar. Tighten the u-bolt hardware to mount the sway bar brackets to
the axle. At this point you can now adjust the stiffness of the sway bar. Change the end link
mount to the hole in the end of the bar to change the stiffness of the bar.