Ohaus Valor 7000 Series COMPACT FOOD SCALES Manual - Manual (Page 16)

EN-14
Valor™ 7000
Series
4.3 Setup Menu
Enter this menu to set scale parameters. Default settings are bold.
Reset
[reset]
Reset the Setup menu to factory defaults.
NO = not reset
YES = reset
Power on unit
[pwWr.UN]
Set the unit of measure displayed at startup.
AUTO = last unit in use when turned off
kg = kilograms
g = grams
lb = pounds
oz = ounces
lb:oz = pound ounces
Zero Range
[ZErO]
Set the percentage of scale capacity that may be zeroed.
2% = zero up to 2 percent of capacity
10% = zero up to 10 percent of capacity
Auto Tare
[A.tArE]
Set the automatic tare functionality.
OFF = Automatic Tare is disabled
ON = the first stable gross weight is tared
ON-ACC = stable gross loads within the accept limits are tared (in Check weighing mode)
Beeper Signal
[Bp.sIG]
Set how the beeper responds in Check Weighing mode.
OFF = the beeper is disabled
ACCEPT = the beeper will sound when the weight is within the Accept range.
UNDER = the beeper will sound when the weight is below the Under setting.
OVER = the beeper will sound when the weight is above the Over setting.
OVER- = the beeper will sound when the weight is below the Under setting or above the
UNDER Over setting.
Beeper Key
[BP.key]
Set whether the beeper sounds when a button is pressed.
OFF = no sound
ON = sound
Reset:
no
, yes
Power On Unit: auto, kg, g, lb, oz, lb:oz
Zero Range: 2%, 10%
Auto Tare:
off
, on, on-acc
Beeper Signal: off, accept, under, over, under-over
Beeper Key:
off
, on
IR Func:
disp
, zero, func, tare, print
IR Adjust: off, low, high
Accumulation: off, auto, manual
End Setup: Exit menu