Ohaus E1RW60 Explorer Balances - Manual (Page 81)

27
Mode
Units
Setup Print Enter
4.6 RS232
The RS232 menu provides communication parameters which can be set to accommodate external printers or
computers. It contains five submenus: Baud rate, Parity, Data, Stop bit and Lock ON or OFF which enable you
to program balance parameters and to lock the settings.
Setup
Use keys to change, press Enter
Change
Baud Rate
This submenu is used to select the desired baud rate. There are five available baud rates to choose from: 300,
1200, 2400, 4800 and 9600. The default setting is 2400.
Parity
Parity can be set to Odd, Even or None. The default setting is None.
Data Bits
To set the number of data bits to 7 or 8. The default setting is 7.
Stop Bits
The number of stop bits can be set to 1 or 2. The default setting is 2.
Lock
Lock ON/OFF can only be changed when the hardware Lock Switch is set OFF/disabled. A menu is locked when
the menu lock is set ON and the Lock Switch is ON. Lock when selected and turned on, locks all of the entries
made under the RS232 menu. In the locked condition, items may be looked at but not changed in the menu.
When set off, entries may be changed. OFF is the default setting.
Procedure
• Press the Setup button, CAL is displayed.
• Press or button until RS232 is displayed.
• Press Enter button to save setting.
• Press or button until either BAUD, PARITY,
DATA, STOP, LOCK or EXIT is displayed.
• Press Enter button to save setting.
• Press or button and select the desired
menu setting.