Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA - Manual (Page 10)

25.
Install the supplied rubber
hanger onto the Banks hanger
bracket.
26.
Install the driver-side tailpipe
into the top Y-pipe outlet. Install the
driver-side tailpipe hanger into the
vehicle rubber hanger.
27.
Install the passenger-side
tailpipe into the lower Y-pipe outlet.
Install the passenger-side tailpipe
hanger into the vehicle rubber
hanger.
28.
Move the spare-tire to the rear
of the vehicle and center between
the dual tailpipes. Tighten the spare
tire with the manufacture tire tool
so that it is retained or in place (See
Figure 6).
29.
Un-clip the axle vent hose outlet
attached to the bed near the spare
tire. Re-route the vent hose on top of
the fuel tank and attach to the bed
away from the driver side tailpipe.
Zip tie the vent hose and brake line
to the emergency brake cable, away
from the tailpipe.
30.
Adjust each of the pipes to
ensure that all of the hanger pins
are parallel with the frame-mounted
pins and fully inserted in the vehicle’s
rubber grommets.
31.
Be sure that the two (2)
tailpipes are completely engaged
into the Y-pipe. Rotate the tailpipe
until the hanger pins are parallel
with the frame-mounted pin. NOTE:
Recommended distance between
exhaust tip and body is a half ( 1 ⁄ 2 ”)
inch.
32.
Beginning with clamps closest to
the catalytic converter, and working
your way back. Align the saddle
clamps at the beginning of the slots
(on the 1 ⁄ 2 ” circle punch) and evenly
torque the 2-studs on the clamp.
Note: Whenever possible, tack
weld slip connections to prevent
disengagement is recommended.
33.
Remove the protective covering
from the tailpipe tip. Caution: the
protective covering may ignite
and burn if not removed prior to
running the engine.
-EnD, SECTIOn 1-
DRIVER SIDE
TAILPIPE
DRIVER SIDE
FRAME
HANGER
BRACKET
7/16” BOLT
& WASHER
SPARE
TIRE
7/16”
NUT &
WASHER 2“ X 2”
PLATE
Figure 5
BANKS
DRIVER SIDE
TAILPIPE
ZIP TIE ON
VENT HOSE
& BRAKE LINE
BANKS
PASSENGER SIDE
TAILPIPE
ADJUST SO THAT
SPARE TIRE TO
TAILPIPE CLEARANCE
IS THE SAME
MOVE SPARE
TIRE TOWARDS
REAR OF
VEHICLE
Figure 6
10
96812 v.7.0