Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA User Manual
Page 25
17.
In the engine compartment,
locate the BLAcK Ground wire with
the ring terminal on the EconoMind
Diesel Tuner wire harness. Install this
ring terminal onto the fender ground
stud, over the ring terminals already
there, and re-install the nut. See
Figure 30.
Note: Go over the entire installation
as a precautionary check to ensure
that all clamps are tight, wiring
and hoses are properly routed, and
connections are correct and tight.
Make sure that the EconoMind wire
harness is not lying in the way of the
brake and gas pedals, or any moving
parts.
18.
(Engine compartment) After
confirming all of the system
connections are correct, make
sure the entire mounting surface is
clean and free of dirt and oil before
mounting the EconoMind Diesel
Tuner. clean and dry as required
using a cloth dampened with rubbing
alcohol or a similar cleaning solution.
CAuTIoN: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result. Mount the EconoMind
Diesel Tuner on the top of the
fuse box cover as shown in Figure
19, by peeling the protective
backing off the adhesive tape on
the back of the EconoMind Diesel
Tuner.
19.
Hold the EconoMind Tuner
against the fuse box cover for
approximately 1 minute while
applying pressure to allow the
adhesive to properly adhere to the
surface.
-EnD, SECTIOn 5-
Figure 29
Figure 30
96812 v.7.0
25