Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA User Manual
Page 19
1.
Place the EconoMind Diesel
Tuner box on top of the fuse box
located in the left front side in the
engine compartment. See Figure
19. The in-cab cable with the three
small connectors will be routed into
the cabin via the grommet on the
firewall. The other two harnesses
will be routed under the intake to
their respective locations listed in the
following steps.
2.
Locate the rubber grommet on the
drivers side firewall. Using a utility
knife, make a 1.5-inch-long slit in the
grommet next to the wire harness.
Be careful not to cut or damage
the harness. See Figure 20 for the
proper location of the required cut.
Insert a screwdriver from the engine
compartment into the cut hole and
gently thrust it through the grommet.
3.
Inside the vehicle, remove the
lower dash panel beneath the
steering column by removing the two
(2) screws at the bottom of the panel.
Retain the screws for re-installation.
NOTE: There are also two (2) clips
located at the top corners of the
panel, which hold the panel in place.
These clips can be released by gently
pulling on the corners of the panel.
Use caution to avoid damaging the
panel during removal.
Section 5
BANKS ECoNoMIND DIESEl TuNER INSTAllATIoN
Figure 18 EconoMind and supplied wiring harnesses
96812 v.7.0
19