Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA User Manual
Page 16
40.
Install the supplied Stat-O-Seal
washers on the two driver side
(longer) studs. Driver side studs are
longer than passenger side studs.
The washers should be installed in
a twisting motion to prevent tearing
their sealing element. Install the
supplied
5
⁄
16
” flat washer on all
studs, then fasten with the supplied
5
⁄
16
-24 nylock nuts. The nuts should
be tightened to 12 ft-lbs (144 in-lbs).
An exploded view of the High-Ram
assembly is shown in Figure 16.
41.
Gently bend the engine oil
dipstick tube to it’s mounting location
on the High Ram as shown in Figure
16. Secure the dipstick tube with
the factory bolt that was previously
removed.
42.
Remove rag that was used to
cover the boost tube opening. Make
the connection between the driver
side boost tube and the High-Ram.
Tighten all the driver side hose
clamps to 5 ft-lbs (60 in-lbs).
-EnD, SECTIOn 2-
Figure 16. Exploded view of the High-Ram assembly
16
96812 v.7.0