Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA User Manual
Page 20
4.
Remove the electrical connector
bracket on the left hand side of the
support below the steering column in
front of the firewall by removing the
two (2) bolts. This will allow access
to the inner grommet. See Figure 21.
5.
cut the grommet on the firewall
inside the vehicle along the hole
created by the screwdriver in Step 2.
6.
Locate the in-cab cable with the
three connectors. From the engine
compartment, push the in-cab cable
through the hole cut in the firewall
grommet. NOTE: Taping the end of
the cable to a piece of stiff wire (i.e.
coat hanger) may make routing the
cable through the firewall a simpler
task. The stiff wire should be pushed
through the slit in the grommet and
then the wires can be attached to
the stiff wire and pulled through the
hole in the grommet.
CAuTIoN: Pull gently to avoid
damage to the cable connectors.
Always pull on the cable sheath
rather than the wires themselves.
Figure 20
Figure 19
20
96812 v.7.0