Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA User Manual
Page 22
9.
In the engine compartment find
the Fuel Rail Pressure (FRP) sensor
on the fuel rail. It is located on the
drivers side of the engine. Unplug
the factory connector and plug it
into the corresponding male FRP
sensor connector on the EconoMind
harness. Plug the EconoMind’s
female FRP sensor connector into the
sensor. See Figure 23.
10.
Locate the Manifold Pressure
(MAP) sensor on top of the intake
manifold. Unplug the factory
connector and plug it into the
corresponding male MAP sensor
connector on the EconoMind
harness. Plug the EconoMind’s
female MAP sensor connector into
the sensor. See Figure 23.
CAuTIoN: The Camshaft Position
(CMP) sensor and the Crankshaft
Position (CKP) sensor have the
same type of connectors and
they are in close proximity to
one another. Make sure the
right connectors are used when
installing these connections.
Refer to Figure 24. for their
locations on the EconoMind
Diesel Tuner wire harness.
Figure 23
Figure 24
22
96812 v.7.0