Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '03-05 For use with PowerPDA User Manual
Page 24
15.
Remove the fuse box cover,
located in left front side of the engine
compartment. Locate the mini-fuse
#50 and remove it. Install the mini-
auto blade tap onto the removed
mini fuse as shown in Figure 27.
Re-install the mini fuse with the
attached blade tap into location
#50 as shown in Figure 28. Note:
Install the mini-auto blade tap on the
terminal leg closest to the firewall.
This is the “hot” side of the circuit.
Caution: It is very important that
you select the proper fuse. The
Banks EconoMind Diesel Tuner
will not function properly if
installed incorrectly.
16.
It is recommended to cut a small
notch in the fuse box cover as shown
in Figure 29, to avoid a crimped or
stressed wire. Locate the RED/WHT
wire with the Power Terminal on the
EconoMind tuner wire harness and
connect it to the mini-fuse blade
tap. Replace the fuse cover and
make sure not to pinch the RED/WHT
power wire.
Figure 27
Figure 28
24
96812 v.7.0