Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ - Manual (Page 10)

10
96816 v.3.0
Figure 1.5 Short-bed model shown
23.
Install the passenger-side
tailpipe (shorter) into the lower
Y-pipe outlet. Install the passenger-
side tailpipe hanger into the vehicle
rubber insulator.
24.
Adjust each of the pipes to
ensure that all of the hanger pins
are parallel with the frame mounted
pins and that the rubber hangers are
all positioned slightly forward (See
Figure 1.2). This allows the hangers
to be properly positioned once the
exhaust system reaches operating
temperature.
25.
Be sure that the two (2) tailpipes
are completely engaged into the
Y-pipe. Rotate the tailpipe until the
hanger pins are parallel with the
frame-mounted pin. Be sure both
tailpipe tips look symmetrical.
NOte: Minimum distance between
exhaust tip and body is a half ( 1 ⁄ 2 )
inch.
26.
Tighten the head pipe V-band
clamp to 12 ft-lbs (if previously
loosened).
27.
Align the saddle clamps on
the radius of the corresponding
pipe slots. Figure 1.3 illustrates the
proper location of an exhaust clamp
on a tubing joint. Torque the nuts
on each of the exhaust clamps to
35 ft-lbs. Torque the four (4) factory
flange nuts, previously removed, to
30 ft-lbs. Torque the hanger bracket
1 ⁄ 2 “ hardware to 65 ft-lbs.
28.
Using the three (3) supplied wire
ties, tie any hoses, brake lines or
harnesses a minimum of four inches
away from the exhaust/tail pipes.
29.
Remove the protective covering
from the tailpipe tip.
Caution: the protective covering
may ignite and burn if not
removed prior to running the
engine.
30.
The Banks Monster Exhaust
installation is now complete.
-END, SEcTION 1-