Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ - Manual (Page 13)

96816 v.3.0
13
10.
Remove the low pressure
A/C condenser line from the line
retainerattached to the upper fan
shroud.
11.
Remove the upper section of
the fan shroud from the vehicle.
Take care not to damage the face
of the radiator when removing the
shroud.
12.
Remove the two upper
condenser mounting bolts that
attach to the radiator cross brace.
13.
Mark the location of the hood
latch, then remove the hood latch
from the latch support. The latch
is held in place by three bolts. The
latch support is shown in Figure 2.5.
It is not necessary to remove the
cable from the latch, just place the
latch and cable assembly out of the
way.
14.
Remove the two bolts that
attach the latch support to the
radiator cross brace and the 4 lower
attachment bolts (2 per side). The
two bolts that attach the upper
support to the radiator cross brace
are accessed from the engine
compartment side of the vehicle.
16.
Swing the latch support forward
as shown in Figure 2.7.
17.
Pull the air conditioning
condenser out of it’s lower mounts,
and place it against the latch
support.
18.
Remove the two upper Charge
Air Cooler (CAC) mounting bolts and
unfasten the fender support rod
from the cross brace as shown in
Figure 2.8.
19.
Remove the 6 bolts (3 per side)
that secure the radiator cross brace.
The cross brace is shown in Figure
2.8. The bolts are on the bottom side
at each end of the support. Remove
the cross brace from the vehicle.
20.
Remove the air box-mounting
tray from the vehicle shown in
Figure 2.9.
Figure 2.7 Latch Support Moved Out of the Way
Figure 2.8 Upper Intercooler (CAC) Attachment Bolt.
Figure 2.9 Air box tray