Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ - Manual (Page 30)

30
96816 v.3.0
8.
Locate the RJ12 Cable (similar to
telephone connector) on your Banks
OBDII interface cable . See Figure 6.4.
9.
Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
Bridge Module. See Figure 6.5.
10.
Route the Banks iQ USB
interface cable from the Banks iQ
Bridge Module under the dash and
out through the fuse access panel
opening. The cable can be slid under
the door frame’s seal and run up
to the top of the dash. Pull enough
cable to reach the Banks iQ and
connect it to the USB receptacle on
the left side of Banks iQ. See Figure
6.2. Snap the fuse access panel back
in place making sure not to pinch the
wire.
WaRNING: THE CHaRGING CaBLE
CONNECTED TO THE BaNkS
iQ IS DESIGNED TO SuPPLY
a CONSTaNT LOW-VOLTaGE
POWER SOuRCE (+5VDC) TO
THE BaNkS iQ aND IS “LIVE”
aS LONG aS THE SYSTEM’S
OBD II INTERFaCE CaBLE OR
BaNkS WIRING HaRNESS IS
COMPLETELY INSTaLLED aND
THE uSB CaBLE CONNECTOR
IS PLuGGED INTO BaNkS iQ.
aLTHOuGH THIS CHaRGING CaBLE
IS SHORT aND ITS CIRCuITRY IS
FuSE-PROTECTED, THE uSER IS
ExPECTED TO TakE aPPROPRIaTE
MEaSuRES TO PREVENT SMaLL
CHILDREN aND/OR PETS FROM
CONTaCT WITH aNY PaRT OF THIS
SYSTEM.
11.
Secure Banks iQ Bridge Module
under the dash to any dash frame
support using the supplied cable ties.
Use the cable tie support loops on the
side of the Bridge Module to securely
fasten it under the dash.
12.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
13.
Reinstall the lower knee panel
back in place with the factory
hardware. Tuck any excess cable
behind it for a clean appearance.
-END, SEcTION 6-
Figure 6.3
Figure 6.4 Banks iQ System
Figure 6.5 Banks Bridge Module