Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ User Manual
Page 24
24
96816 v.3.0
NOte: Be careful when removing
the MAF Sensor. When removing
the MAF sensor, grasp its body and
pull up and out. Do not twist or bend
when removing.
9.
Install the supplied Banks MAF
sensor o-ring onto the MAF sensor.
Ensure o-ring is mounted flush to
MAF sensor edge as shown (Figure
4.4).
NOte: Retain the stock 0-ring. the
Banks o-ring will be slid over the
stock o-ring on the MAF sensor.
10.
Locate your Banks Ram-Air
intake tube in your kit. Install the
stock MAF sensor (with the additional
Banks
gasket) to MAF sensor mounting
boss as shown. Tighten the screws
(included) to 3 in/lbs. See Figure 4.5.
NOte: ensure correct alignment as
shown otherwise screw holes will not
align with screw holes in the Banks
Ram-Air intake tube.
Caution: DO NOT OVER TIGHTEN
SCREWS
11.
Locate the previously removed
stock air box and remove the stock
air filter Minder. Make sure to
remove the stock air filter Minder
rubber grommet as well. See Figure
4.6.
12.
Locate the Banks Ram-Air filter
housing cover. Install the air filter
Minder’s rubber grommet into the
Banks Ram-Air filter housing cover.
Once the rubber grommet is installed
flush into the Banks Ram-Air cover,
then the filter Minder can be inserted
into the rubber grommet. Make sure
the air filter Minder is installed flush
to rubber grommet.
13.
Locate the Banks Ram-Air filter
element and the Banks air filter
hose clamp. Loosely fit the filter
clamp to the air filter element.
NOte: See Figure 4.7 to reference
the correct alignment locater groove
to the Banks Ram-Air filter.
Figure 4.5
Figure 4.4
Figure 4.6