Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ User Manual
Page 32
32
96816 v.3.0
6.
After confirming the locating
washer is in the #6 location, install
the switch through the
3
⁄
8
” hole
on the backside of the instrument
panel. The alignment pin should rest
in the
1
⁄
8
” hole and with the switch
fully rotated counter clockwise; the
shaft’s flat side should be facing
the steering column. Secure switch
with internal tooth washer and nut.
Snug the washer; be careful not to
over torque the nut and damage the
plastic threads.
7.
Install the knob onto the shaft
facing the #1 Level on the Power
Level Selector Switch label. On the
knob, snug the two (2) set screws
with the supplied 0.050” hex key
wrench.
8.
Route the Power Level Selector
Switch cable down to the EconoMind
Tuner’s three-connector cable
underneath the dashboard, and
reinstall the IP to the dashboard.
9.
Connect the Power Level Selector
Switch Cable’s 2-pin receptacle to
the 2-pin plug on the EconoMind
Tuner’s grey three-connector cable.
Reconnect the ground cables to the
vehicle batteries.
-END, SEcTION 7-
Figure 7.3
Figure 7.5
Figure 7.4