Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ - Manual (Page 12)

12
96816 v.3.0
park/turn signal lamp assembly by
depressing the outboard retaining
clip, then rotating the assembly
outward as shown in Figure 2.4.
Remove the bulbs from the turn
signal lamp assembly by turning
the lamp sockets a quarter turn
counterclockwise.
NOte: the headlamp is easily
disengaged and does not require
force to be removed once the
outboard clip has been depressed.
Attention: Number and location of
bolts on the headlamp assembly
may vary by model and year.
NOte: the inner fenderwell cover
must be removed to access the
bottom bolt. Next, remove the (3
per side) bolts to the head assembly
grill support bracket. Disconnect the
connectors from the backside of the
headlamp assembly from both driver
and passenger headlamp assemblies.
Remove the headlamp assemblies.
NOte: Slide the headlamp assembly
toward the center and forward of
the vehicle to remove. the turn
signals are built into the headlamp
assembly.
7.
Remove the plastic headlamp
mounting structure. Remove the
plastic headlamp mounting structure
on the driver and passenger side
of the vehicle shown in Figure 2.5.
There are (6x) bolts, (2x) torx head
bolts, (1x) push-in retainer and (1x)
large clip that must be disconnected
to remove the piece from the
vehicle, per side. The plastic piece
that resides by the bumper must
be detached from the headlamp
mounting structure, but will remain
on the vehicle. The retaining clip
that attaches the hood latch cable to
the support structure must also be
removed on the driver’s side.
8.
Remove the two bolts that secure
the upper fan shroud to the upper
radiator cross brace. Remove the
four push-in retainers (2 per side)
that attach the upper section to the
lower section of the fan shroud.
These retainers are removed by
pulling up on the center pin then
prying the entire retainer assembly
out as shown in Figure 2.2.
9.
Carefully remove the transmission
module from the upper fan shroud.
Lay the module to the side. See
Figure 2.6.
Figure 2.4 2006-07 LBZ: Parking Lamp Assembly Removal
Figure 2.5 ‘06-07 LBZ: Removal of Headlamp/Parking Lamp Assembly Support Structures.
Figure 2.6 transmission module