Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Systems- Stinger system '03-04 User Manual
Page 10
42.
Find the Fuel Rail Pressure
(FRP) sensor on the fuel rail. It is
located on the drivers side of the
engine. Unplug the factory connector
and plug it into the OttoMind
harness. Plug the OttoMind FRP
connector into the sensor. See Figure
10
.
43.
Locate the Manifold Pressure
(MAP) sensor on top of the intake
manifold. Unplug the factory
connector and plug it into the
OttoMind harness. Plug the OttoMind
MAP connector into the sensor.
See Figure
10
.
CAUTION: The camshaft position
sensor and the crankshaft position
sensor have the same type of
connectors and they are in close
proximity to one another. Make
sure the right connectors are used
when installing these connections.
Refer to Figure
11
for their
locations on the OttoMind wire
harness.
Figure 10
Figure 9
10 |
9 6 7 6 7 v . 3 . 0