Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Systems- Stinger system '03-04 - Manual (Page 17)

side of the housing and slide the
cover toward the engine.
63.
Remove the old air filter
element from the filter housing and
replace it with the Banks Ram-Air
filter element. Place the Banks filter
element in the right orientation
and check the filter seal is seating
properly around the housing to
ensure no leakage.
For proper maintenance and service
on the Banks Ram-Air Filter, refer to
cleaning and Oiling The Banks Ram-
Air Filter on page 22.
64.
Slide the tabs on the cover into
the slots on the air filter box. Press
the cover down gently and re-attach
the four (4) clips on the side to
securely clamp the cover.
Learning Transmission
Your Ottomind displays the
“4,3” diagnostic code (refer to
“TroubleShooting” section on how to
read codes) when it needs to learn
your transmission configurations. This
always occurs when the OttoMind is
first installed on the truck.
Banks OttoMind is equipped with
advanced safety features to preserve
your automatic transmission. One of
them is the capability to detect the
occurrence of transmission slip, and
it will automatically derate the engine
output power accordingly. Before
this safety feature can take effect, the
OttoMind needs to learn that your
truck is equipped with an automatic
transmission.
65.
Reconnect all battery terminals.
The following driving test shall be
performed in an area where speeds
of this nature are safe and traffic
is light. For vehicles with a manual
transmission, follow Steps 66 through
67. For vehicle with automatic
transmission, follow Steps 68 through
70.
While driving, listen for any exhaust
leaks or rattles, or intake boost leaks.
After the engine cools, re-tighten
clamps and hoses if leaks are
detected.
Figure 21
9 6 7 6 7 v . 3 . 0
| 17