Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Systems- Stinger system '03-04 User Manual
Page 12
For 2003 automatic transmission
vehicles, follow Steps
46
through
49
.
For 2003 vehicles with a manual
transmission, skip to Step
49
.
For 2004 vehicles with an
automatic transmission, follow
Steps
50
through
52
.
For 2004 vehicles with a manual
transmission, skip to Step
52
.
46.
FOR 2003 AUTOMATIC
TRANSMISSION VEHICLES ONLY:
Route the gray Banks Tcc monitor
wire along the top of the firewall
toward the PcM on the passenger
side. Undo the clips (10 locations)
and lay the gray wire next to the
factory wires. See Figure
14
. Use a
cable tie to secure the Tcc wire at the
outlet.
47.
Locate the three (3) PcM
connectors on the passenger side. On
the middle connector (usually white),
find the orange wire with black stripe.
Remove electric wire tape on the
factory harness if necessary and install
a T-tap. Plug the Tcc gray wire into
it. See Figure
15
. Re-install the clips
along the top of the firewall. NOTE:
Disconnecting the PCM connection
might make the task easier.
Figure 13
Figure 14
12 |
9 6 7 6 7 v . 3 . 0