Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Systems- Stinger system '03-04 - Manual (Page 21)

the system includes a by-pass plug
that must be connected to the
white 8-pin connector (next to the
10-pin connector) on the Banks wire
harness. Failure to utilize the by-pass
plug will result in a “check Engine”
light on the dash and a Diagnostic
Trouble code being stored in the
factory computer and the engine will
not start.
OttoMind Mounting
77.
After confirming the
functionality of the system, make
sure the entire mounting surface is
clean and free of dirt and oil before
mounting the OttoMind. clean
and dry as required using a cloth
dampened with rubbing alcohol or
similar cleaning solution.
CAUTION: Do not spray fluid
directly onto any electrical
equipment, or equipment
damage may result.
Mount the OttoMind on the back
of the lower dash panel as shown
in Figure 24 by peeling off the
protective backing off the adhesive
tape on the back of the OttoMind
box.
Note: The OttoMind may not clear
the steering structure if it is mounted
differently.
78.
Hold the module against the
panel for approximately 1 minute
while applying pressure to allow the
adhesive to properly adhere to the
surface.
79.
Re-install the electric connector
bracket that was removed in Step
4 below the steering column in the
front of the fire wall with the original
two (2) bolts.
80.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash. Secure
all wiring under the hood away
from heat sources or sharp edges.
Re-install the lower dash panel with
the original 2 bolts. Your Banks
product installation is complete.
Figure 24
9 6 7 6 7 v . 3 . 0
| 21