Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Systems- Stinger system '03-04 - Manual (Page 23)

NOTE: This procedure should only be
performed if:
(a) A ”4,2” code for transmission slip
detection is repeatedly set or will
not clear and the transmission is not
actually slipping; or
(b) The OttoMind is moved to a new
vehicle; or
(c) The speedometer has been
recalibrated for different gearing or
tire size; or
(d) Instructed to do so by Banks
Technical Staff.
Your OttoMind also has the capability
to clear the information related to the
learned transmission type and gear
ratios. The diagnostic code “4,3” will
reappear after the procedures are
carried out correctly. Follow the steps
below to unlearn the transmission on
your OttoMind.
CAUTION: The following
procedures can only be carried out
with the engine off.
B1. Turn the vehicle key to the ON
position but DO NOT start engine.
B2. Fully depress the throttle pedal
and then release it completely.
Repeat for 5 times. The green LED
will flash when this is completed
successfully.
B3. Turn key off. Wait 10 seconds
or until the green LED goes off and
stays off. Turn key to on position but
DO NOT start engine.
B4. Fully depress the throttle pedal
and then release it completely.
Repeat for 5 times. The “4,3”
diagnostic code will display when this
is completed successfully.
NOTE: When the transmission type
and gear ratios are cleared (with
code “4,3” displayed), the engine
power returns and remains in stock
level until the OttoMind re-learns
the transmission and code “4,3” is
eliminated. Follow the procedures
in “LEARNING TRANSMISSION” on
page
17 to eliminate code “4,3”.
CLEARING TRANSMISSION INFORMATION
9 6 7 6 7 v . 3 . 0
| 23