Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind ('07-09) LMM (PDA) Compatible w_Optional PowerPDA User Manual
Page 15
96507 v.4.0
15
13.
Swing the latch support forward
as shown in Figure 13.
14.
Pull the air conditioning condenser
out of it’s lower mounts, and place it
against the latch support.
15.
Remove the two upper Charge
Air Cooler (CAC) mounting bolts and
unfasten the fender support rod from
the cross brace as shown in Figure 14.
16.
Remove the 6 bolts (3 per side)
that secure the radiator cross brace.
The cross brace is shown in Figure
14. The bolts are on the bottom side at
each end of the support. Remove the
cross brace from the vehicle.
17.
Remove the air box support
bracket shown in Figure 15. There is
an a/c condenser line retaining clip and
a plastic fastener that attaches to the
inner fenderwell that must be removed
before the bracket can be liberated
from the vehicle.
18.
Trim the air box support
bracket per the supplied templates
(Templates 1, 2) in the center of this
manual. Figure 16 shows the bracket
before and after trimming.
Note: Paint trimmed edge to protect
from rust.
Figure 13 Latch support moved out of the way