Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind ('07-09) LMM (PDA) Compatible w_Optional PowerPDA User Manual
Page 42
42
96507 v.4.0
10.
After confirming the locating
washer is in the #6 location, install
the Switch through the
3
⁄
8
” hole. The
alignment pin should rest in the
1
⁄
8
”
hole. With the Switch fully rotated
counter clockwise the shaft’s flat
side should be facing the driver’s
side door. Secure the Switch with the
internal tooth washer and nut. Snug
the washer; be careful not to over
torque the nut and damage the plastic
threads.
11.
Install the knob onto the shaft
facing the #1 Level on the EconoMind
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
12.
Route the EconoMind Switch
Cable down to the EconoMind Diesel
Tuner’s In-Cab Cable underneath the
dashboard, and reinstall any panel(s)
that were removed.
Note: Take care to keep any cables
away from the pedals or where they
could become tangled.
13.
Connect the EconoMind Switch’s
2-terminal receptacle to the 2-terminal
plug on the EconoMind Diesel Tuner’s
In-Cab Cable.
-END, SEcTION 6-
Figure 37