Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind ('07-09) LMM (PDA) Compatible w_Optional PowerPDA - Manual (Page 7)

96507 v.4.0
7
previously removed air box tray bolts
to secure the Banks Ram-Air filter
housing.
Note: The cutout on Banks Ram-Air
filter housing must face passenger side
fender. See Figure 3.
8.
Locate your Banks Torx tool, T20H
in your Banks Ram-Air kit. Use the Torx
tool bit to remove the two (2) screws
securing the MAF sensor to the stock
air box cover.
Note: Be careful when removing the
MAF Sensor. When removing the MAF
sensor, grasp its body and pull up
and out. Do not twist or bend when
removing.
9.
Remove stock MAF gasket. Locate
the Banks MAF sensor gasket supplied
in your kit. Install Banks gasket as
shown (Figure 4).
10.
Locate your Banks Ram-Air intake
tube in your kit. Install the stock MAF
sensor (with the additional Banks
gasket) to MAF sensor mounting
boss as shown. Tighten the screws
(included) to 3 in/lbs.
Note: Ensure correct alignment,
otherwise screw holes will not align
with screw holes in the Banks Ram-Air
intake tube.
CAUTION: Do not over tighten
screws.
11.
From the stock air box, remove
the stock air filter Minder. Make sure
to remove the stock air filter Minder’s
rubber grommet as well. See Figure 5.
12.
Locate the Banks Ram-Air filter
housing cover. Install the air filter
Minder’s rubber grommet into the
Banks Ram-Air filter housing cover.
Once the rubber grommet is installed
flush into the Banks Ram-Air cover,
then the filter Minder can be inserted
into the rubber grommet. Make sure
the air filter Minder is installed flush to
rubber grommet.
Figure 2