Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind ('07-09) LMM (PDA) Compatible w_Optional PowerPDA User Manual
Page 36
36
96507 v.4.0
7.
Next, connect the 6-terminal
connector on the Banks OBD II
Interface Cable to the 6-pin connector
on the EconoMind Tuner harness.
8.
For the cleanest PowerPDA
installation (Figure 26), remove the
fuse access panel by pulling it out
from the side of the dash. Route the
RJ12 connector (phone like connector)
on the Banks OBD II Interface Cable
under the dash and out where the
fuse access panel was. The RJ12
connectors’s cable can be slid under
the door frame’s seal and run up to
the top of the dash. Plug the RJ12
connector into one of the receptacles
in the base of the PDA docking station.
Re-install the fuse access panel.
9.
Plug the docking station’s charging
cable (seen in Figure 25) into the
charging receptacle on the lower edge
of the PowerPDA.
Figure 27
Figure 26